Sewer Overflow formula (Water Overlay)

Please note: This page is currently being updated.

Overflow from the sewer is calculated for the entirety of the sewer, and the single attached sewer overflow.

The sewer base height is located at the height indicated by the sewer overflow:

B_s = B_o

The water level at the sewer is calculated based on that height:

w_s = h_s + B_a

The sewer overflow threshold height H_o within the sewer is calculated as:

H_o = H_s * T_o

Water only flows out of the sewer if:

h_s > H_o and

h_s + B_s > w_o

The amount that can overflow relies on both the water level at the sewer overflow itself as well as the sewer overflow threshold and the stored sewer water:

Δh = min ( h_s - H_o , w_s - w_o)

The flow is then calculated with the SEWER_OVERFLOW_SPEED attribute of the sewer overflow and the maximum speed with which water can flow through the sewer overflow:

Δw = min( Δh, Δt * q_o / A_s)

The amount of water added to the exit cell(s) of the sewer overflow:

Q_t = Δw * A_s

where:

• B_o = The surface height at the centerpoint of the sewer overflow, relative to datum.
• B_a = The height of the sewer relative to datum, as defined by the SEWER_OVERFLOW of the sewer overflow.
• B_s = The assumed surface height of the sewer, relative to datum.
• w_o = The water level at the sewer overflow's exit, relative to datum.
• w_s = The water level in the sewer, relative to datum.
• H_o = The height of the sewer overflow threshold in the sewer.

• h_s = The sewer water height.
• H_s = The SEWER_STORAGE attribute of the sewer area, the maximum water height allowed in the sewer.
• Δh = The amount of water that can flow out of sewer based on the threshold and the water levels inside and outside the sewer.
• Δw = Water level change in the sewer, due to sewer overflow taking place.
• Δt = Computational timestep.

• A_s = The surface area of the sewer.

• q_o = The SEWER_OVERFLOW_SPEED attribute of the sewer overflow.
• T_o = The SEWER_OVERFLOW_THRESHOLD, the threshold factor indicating the fraction of the sewer's storage height that is blocked by the sewer overflow's threshold.
• Q_t = The amount of water which flows out of the sewer through the sewer overflow.

Notes

• The sewer's surface area is computed as the amount of sewered grid cells times the size of a grid cell.
• The sewer's height relative to datum is not defined in the sewer itself. It is relative to the sewer overflow and determined by the SEWER_OVERFLOW attribute of the overflow.

Related

The following topics are related to this formula.

Structures and features

Sewer area

Sewer overflow

Models

Surface model

Sewer model

Water Module

Tutorials

Overview

Theory

Benchmarks