How to add and configure hydraulic structures (Water Overlay)

Please note: This page is currently being updated.

Manually add and remove hydraulic structures

Editor → Current Situation (Ribbon tab) → Buildings (Ribbon bar)

How to add a hydraulic structure (example: inlet):

1. From the Buildings dropdown select "Add Building".
2. Name your new building.
3. Click Change Function.
4. Select (1) the correct category > (2) the desired function > (3) Apply.
5. Click Draw Area.
6. Select (1) one or more grid cells on the map for the desired location of the new building > (2) Apply Selection.
7. In the Configuration Wizard of the Flooding Overlay at (1) the corresponding step > select (2) the new building > (3) Next.
8. Finally, test the new hydraulic structure by running the simulation.

• 

  1. Select Add Building.

• 

  2. Name your new building.

• 

  3. Click Change Function.

• 

  4. Select (1) the correct category > (2) the desired function > (3) Apply.

• 

  5. Click Draw Area.

• 

  6. Select (1) one or more grid cells on the map for the desired location of the new building > (2) Apply Selection.

• 

  7. In the Configuration Wizard of the Flooding Overlay at (1) the corresponding step > select (2) the new building > (3) Next.

• 

  8. Finally, test the new hydraulic structure by running the simulation.

How to remove a hydraulic structure (example: inlet):

1. From the Buildings dropdown select "Show Buildings".
2. Select (1) the building you whish to remove > (2) Remove > (3) Yes.

• 

  1. Select Show Building.

• 

  2. Select (1) the building you wish to remove > (2) Remove > (3) Yes.

Import and export hydraulic structures

Editor → Current Situation (Ribbon tab) → Buildings (Ribbon bar)

How to import a hydraulic structure:

1. From the Buildings dropdown select "Import Geo Data".
2. Click Next and select your import method.
3. Proceed by following the steps as stated on the Geo Data Wizard page.

• 

  1. Select Import Geo Data.

• 

  2. Select (1) your import method > (2) Next and continue with the subsequent steps.

How to export a hydraulic structure:

1. From the Buildings dropdown select "Export GeoJSON File".
2. (1) Filter on the building type you wish to export > (2) click Export.
3. Proceed by going through the subsequent steps.

• 

  1. Select Export GeoJSON File.

• 

  2. (1) Filter on the building type you wish to export > (2) click Export.