Breach growth formula (Water Overlay): Difference between revisions

From Tygron Support wiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 9: Line 9:
Using the height difference, the breach width increase is calculated.
Using the height difference, the breach width increase is calculated.


: <math>\Delta W_{b,t} = f_{m} * (\sqrt{g} * \sqrt{\Delta h^3} / cs_b ) \cdot \log_{10} (1 + (0.04 * g / cs_b) \cdot \Delta t / 3600)</math>
: <math>\Delta W_{b,t} = f_{m} * (\sqrt{g} * \sqrt{\Delta h^3} / cs_b ) \cdot \log_{10} (1 + (0.04 \cdot g / cs_b) \cdot \Delta t / 3600)</math>


The current breach width is then equal to the last calculated breach width, plus the calculated breach width increment.
The current breach width is then equal to the last calculated breach width, plus the calculated breach width increment.

Revision as of 09:08, 17 October 2019

Water can flow through breaches into levee protected areas. These breaches often start small and grow over time[1].

The water flowing through breaches can originate from an external area outside the project area or an input area within the project area.

First, the difference in height of the water on either side of the breach is calculated.

Using the height difference, the breach width increase is calculated.

The current breach width is then equal to the last calculated breach width, plus the calculated breach width increment.

Wb,t = Wb,t-1 + ΔWb,t

Where:

  • Wb = The BREACH_WIDTH of the breach.
  • Hb,t = The BREACH_HEIGHT of the breach at time t.
  • Wb,t = The calculated breach width, initially equal to Wb.
  • wb,t = water level at breach at time t.
  • we,t = water level at entry area (external or internal) at time t.
  • Δht = The difference between the height of the water columns on either side of the breach at time t.
  • fm = Material factor, set to 1.3 (average for sand and clay levees).
  • g = Acceleration factor of GRAVITY, defined for the Water Overlay.
  • csb = The critical BREACH_SPEED of the breach.
  • ΔWb,t = The calculated width increase of the breach at time t.
  • Δt = Computational timestep.

Notes

Related

The following topics are related to this formula.

Features
Breach
Formulas
Breach flow formula
Models
Surface model

References

  1. Verheij, H.J. ∙ Aanpassen van het bresgroeimodel in HIS-OM: Bureaustudie ∙ found at: http://resolver.tudelft.nl/uuid:aedc8109-da43-4a03-90c3-44f706037774 ∙ (last visited 2019-03-08)

Template:WaterOverlay nav