Pump (Water Overlay)

Pumps are Buildings which can move water against its natural flow. Specifically, a pump with a positive pump speed will pump water from the entry point with a lower water level to the entry point with a higher water level. If no (differing) water levels are defined, the surface height is used instead.

The pump's direction does not change during the simulation.

A pump is a line-based building.

Icon	Key	Unit	Range	Description	Default value
	PUMP_Q	m3/s		The speed at which water is pumped from the lower end-point to the higher end-point.	n/a
	LOWER_THRESHOLD	m + datum		The threshold of the lower end-point of the pump. Water flows from the lower end-point to the higher end-point until the water level at the lower end-point has reached the threshold. If not selected, the Lower Threshold will be ignored as a mechanic.	None
	UPPER_THRESHOLD	m + datum		The threshold of the higher end-point of the pump. Water flows from the lower end-point to the higher end-point until the water level at the higher end-point has reached the threshold. If not selected, the Upper Threshold will be ignored as a mechanic.	None
	PUMP_ANGLE	geo angle (0-360°)	-1.7976931348623157E308 to 1.7976931348623157E308	The top down orientation angle of the pump.	0
	INLET_CAPACITY	m3		The maximum amount of water which can flow in or out through this Pump. Water flowing back in the other direction replenishes the capacity.	0
	PUMP_AREA	boolean		When true the Pump is spread across the entire building surface.	0

Notes

• A negative value for the PUMP_Q attribute is also allowed, in which case water can be pumped in the reverse direction. Sometimes referred to as draining.
• If a pump is placed in a waterway, and the waterway is not otherwise interrupted, water will be able to flow past the pump via the waterway itself. It is recommended to make sure that the waterway is obstructed by an increase in the terrain height in such a way that the only way water can flow from the one end of the pump to the other is via the pump.

How-to's

• How to correct multiple buildings on the same location
• How to correct weir, pump, or culvert drawn as point
• How to correct a building in an uninterrupted waterway
• How to correct a building at the edge of the project area

See also

• Pump formula (Water Overlay)

Explanation about the difference between pumps and inlets/outlets in the Tygron Platform (Dutch only)

---

Water Module

Water Module

Tutorials

Overview

Theory

Benchmarks

Group

Hydraulic structures

Inlet

Inlet q • Inlet area • Inlet capacity •  Lower threshold •  Upper threshold • Inlet underground

Pump

Pump q •  Lower threshold •  Upper threshold • Pump angle • Pump capacity • Pump area

Culvert

Culvert diameter • Culvert rectangular height • Culvert threshold • Culvert n

Weir

Weir height • Weir width • Weir angle • Weir coefficient • Weir target level

Sewer overflow

Sewer overflow • Sewer overflow speed

Drainage

Drainage q • Drainage datum • Drainage active • Drainage overflow threshold

Output

Object flow output • Object height output • Object datum output a • Object datum output b • Object width output

Related

Building attributes • Hydrological features •  Terrain attributes • Model attributes • Results • Simulation data